Two 2026 Builds: An Aluminum Extrusion Standing Desk and a Neon Picture Frame
A maker documents two 2026 projects: an aluminum extrusion standing desk built on a salvaged Ikea tabletop and a neon acrylic picture frame cut on an Epilog laser.
In 2026, a maker documented two builds. One project used aluminum extrusion, an Ikea tabletop from a dumpster, and electric standing desk legs. The other project started with a print from a cafe in Costa Mesa, California, and ended with a neon green acrylic picture frame that had to be cut in pieces to fit a small laser cutter. Both projects involved working within the limits of the materials and the available cutting equipment.
An Aluminum Extrusion Standing Desk
The largest purchase for these builds was a few hundred linear inches of aluminum extrusion. The maker did not specify the exact profile or wall thickness. Those lengths were assembled into a frame. The frame holds an Ikea tabletop that was pulled from a dumpster. The frame is bolted on top of a pair of beefy electric standing desk legs. The maker used the word “beefy” to describe the legs. The tabletop is not shown in the photo included with the post. According to the maker, the aluminum extrusion frame has been especially useful for bike maintenance, hanging stuff, and arm-wrestling training. For bike maintenance, the extrusion channels give points to hold or clamp a bike. For hanging stuff, the frame works as a mounting surface. For arm-wrestling training, the desk provides a stable plane. The maker lists these uses without additional detail.
A Neon Picture Frame
Work in Progress, a cafe in Costa Mesa, California, sells prints in addition to coffee. The maker’s best friend Cesar bought one of these prints but did not have the large neon acrylic frame that accompanies it. The frame measures roughly 25 by 19 inches. On a flight to New York City, the maker modeled the frame in CAD. The goal was to replicate the original feel as closely as possible using 1/4-inch neon green acrylic stock. The backing and mat are made of birch plywood. Small neodymium magnets snap the mat or poster to the frame.
Working Around the Laser Cutter
The main constraint came from the Epilog laser cutter’s nominal workspace of about 24 by 12 inches. The frame itself is 25 by 19 inches, which exceeds the workspace in both width and height. The width is one inch over the workspace, and the height is seven inches over. Because the full frame could not be cut in one pass, the maker added dovetails and joinery to the backing and mat. These joints split the parts into smaller pieces that fit within the machine’s work area. After cutting, the pieces were assembled into the full 25 by 19 inch frame. The dovetails and joinery are part of the backing and mat, not the acrylic frame itself. The dimensions were planned around the machine’s limits. Total part dimensions fit on the Epilog with just enough margin.